Cisco Nexus 9000 Series 빠른 시작 매뉴얼 - 페이지 9

{카테고리_이름} Cisco Nexus 9000 Series에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco Nexus 9000 Series 14 페이지. Switch chassis
Cisco Nexus 9000 Series에 대해서도 마찬가지입니다: 빠른 시작 구성 매뉴얼 (6 페이지), 구성 매뉴얼 (32 페이지), 구성 매뉴얼 (32 페이지), 매뉴얼 (30 페이지), 설치 매뉴얼 (12 페이지), 설치 (8 페이지), 매뉴얼 (16 페이지)

페이지 인쇄

Installing the Chassis

c) Repeat Step 3 to attach the other slider rail to the other side of the rack.

To make sure that the slider rails are at the same level, you should use a level tool, tape measure, or carefully count

the screw holes in the vertical mounting rails.

Step 4

Insert the switch into the rack and attach it as follows:

a) Holding the switch with both hands, position the two rear rack-mount brackets on the switch between the rack or

cabinet posts that do not have slider rails attached to them (see the following figure).

b) Align the two rear rack-mount guides on either side of the switch with the slider rails installed in the rack. Slide the

rack-mount guides onto the slider rails, and then gently slide the switch all the way into the rack until the front

rack-mount brackets come in contact with two rack or cabinet posts.

c) Holding the chassis level, insert screws (12-24 or 10-32, depending on the rack type) in each of the two front rack-mount

brackets (using a total of six screws) and into the cage nuts or threaded holes in the vertical rack-mounting rails (see

the following figure).

Installing the Switch Using the NXK-ACC-KIT-1RU Rack-Mount Kit

Installing the Chassis