- ページ 11

プリンターアクセサリー CAB ST4/LのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。CAB ST4/L 16 ページ。 Stacker with cutter

Installation

2.4.3

Mounting the Safety Covers

Caution!

Risk of injury!

Without safety covers or with improperly mounted safety covers the reliability and machinery safety cannot

be guaranteed.

 Equip the stacker only with safety covers designated for the media to be used.

 Mount the safety covers in the correct position.

Figure 9

Mounting the safety covers

Note!

For a table width greater than 95 mm for ST4/L or 80 mm for ST4/M no safety covers are needed.

 At ST4/L mount safety cover (5) only.

 At ST4/M mount two safety covers (2,5).

For it :

1. Open cover (1).

2. Loosen each one screw (5) in the side plates (6,9) several turns.

3. Place the hooks (3) of the safety covers (2,8) into the slots (7) and slide the slots (4) under the screw heads (5).

4. Tighten the screws (5).

5. Close cover (1).