CAB ST4/L 운영자 매뉴얼 - 페이지 11

{카테고리_이름} CAB ST4/L에 대한 운영자 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. CAB ST4/L 16 페이지. Stacker with cutter

Installation

2.4.3

Mounting the Safety Covers

Caution!

Risk of injury!

Without safety covers or with improperly mounted safety covers the reliability and machinery safety cannot

be guaranteed.

 Equip the stacker only with safety covers designated for the media to be used.

 Mount the safety covers in the correct position.

Figure 9

Mounting the safety covers

Note!

For a table width greater than 95 mm for ST4/L or 80 mm for ST4/M no safety covers are needed.

 At ST4/L mount safety cover (5) only.

 At ST4/M mount two safety covers (2,5).

For it :

1. Open cover (1).

2. Loosen each one screw (5) in the side plates (6,9) several turns.

3. Place the hooks (3) of the safety covers (2,8) into the slots (7) and slide the slots (4) under the screw heads (5).

4. Tighten the screws (5).

5. Close cover (1).