- ページ 5

エクステンダー DigitaLinx DL-HD2100のPDF クイック・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。DigitaLinx DL-HD2100 8 ページ。 Hdbaset extender set
DigitaLinx DL-HD2100 にも：オーナーズマニュアル (17 ページ), クイック・インストール・マニュアル (8 ページ)

ページを印刷する

1. Verify all components included with the extender set are present before

installation.

2. If the extenders are going to be permanently mounted to a surface, attach the

included mounting brackets with the supplied screws.

3. Turn off power and disconnect the audio/video equipment by following the

manufacturer's instructions.

4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between

the transmitter and the receiver. TIA/EIA-568B straight-through wiring connections

must be used with all HDBaseT extenders.

5. Connect an HDMI cable and any desired control accessories between the

display and the receiver.

6. Connect an HDMI cable and any desired control accessories between the source

and the transmitter.

7. Connect the included power supply to the transmitter or receiver and lock the

power supply to the power connector by twisting the locking collar clockwise.

8. Power on attached audio/video devices.

Passing IR Signals:

The DL-HD2100 is capable of passing IR signals between 33 and 55 KHz. To

prevent damage to any of the electronics, the extenders should be powered off

while inserting or removing any IR components. Inserting an IR transmitter into

the IR IN port may damage the IR circuit for that extender.

IR OUT: The IR transmitter (IR emitter) must be plugged into the IR OUT port.

IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.

To connect to a 3rd party IR system such as a control system, connect the TS

connector of the IR-AC coupling cable to the IR output port of the control

system and connect the TRS connector of the IR-AC cable to the IR IN to either

transmitter or receiver of the DL-HD2100.

Connectivity Instructions