DigitaLinx DL-HD2100 Hızlı Kurulum Kılavuzu - Sayfa 5
Genişletici DigitaLinx DL-HD2100 için çevrimiçi göz atın veya pdf Hızlı Kurulum Kılavuzu indirin. DigitaLinx DL-HD2100 8 sayfaları. Hdbaset extender set
Ayrıca DigitaLinx DL-HD2100 için: Kullanıcı El Kitabı (17 sayfalar), Hızlı Kurulum Kılavuzu (8 sayfalar)
Sayfayı Yazdır
1. Verify all components included with the extender set are present before
installation.
2. If the extenders are going to be permanently mounted to a surface, attach the
included mounting brackets with the supplied screws.
3. Turn off power and disconnect the audio/video equipment by following the
manufacturer's instructions.
4. Connect Category 6 or greater twisted pair cable with RJ45 connectors between
the transmitter and the receiver. TIA/EIA-568B straight-through wiring connections
must be used with all HDBaseT extenders.
5. Connect an HDMI cable and any desired control accessories between the
display and the receiver.
6. Connect an HDMI cable and any desired control accessories between the source
and the transmitter.
7. Connect the included power supply to the transmitter or receiver and lock the
power supply to the power connector by twisting the locking collar clockwise.
8. Power on attached audio/video devices.
Passing IR Signals:
The DL-HD2100 is capable of passing IR signals between 33 and 55 KHz. To
prevent damage to any of the electronics, the extenders should be powered off
while inserting or removing any IR components. Inserting an IR transmitter into
the IR IN port may damage the IR circuit for that extender.
IR OUT: The IR transmitter (IR emitter) must be plugged into the IR OUT port.
IR IN: The IR receiver (IR eye) must be plugged into the IR IN port.
To connect to a 3rd party IR system such as a control system, connect the TS
connector of the IR-AC coupling cable to the IR output port of the control
system and connect the TRS connector of the IR-AC cable to the IR IN to either
transmitter or receiver of the DL-HD2100.
Connectivity Instructions