- ページ 6

エクステンダー DigitaLinx DL-HD2100のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。DigitaLinx DL-HD2100 17 ページ。 Hdbaset extender set
DigitaLinx DL-HD2100 にも：クイック・インストール・マニュアル (8 ページ), クイック・インストール・マニュアル (8 ページ)

DL-HD2100 Owners Manual

Receiver / Front and Back View

1. FRONT PANEL DIAGNOSTIC LEDs;

• POWER -Solid, the DL-HD2100 extender is receiving power from the power supply or from the

remote extender via Category 6 cabling.

• STATUS - Flashes once per second, the HDBaseT processor is running.

• HDCP - Solid, HDCP signal is present in the HDMI stream. Flashes quickly, non-encrypted HDCP signal

is present in the HDMI stream.

• LINK - Solid, the two DL-HD2100 components are communicating via Category cabling.

2. DC 12V

• Locking power port, connect DC12V power adapter to receiver (either power port on transmitter

and receiver can power entire set)

3. HDBT IN

• RJ45 HDBaseT connection. Connect Cat6 cable to transmitter

4. IR In / IR OUT

• 3.5mm IR input port for connection to IR receiver or IR system

• 3.5mm IR output port for connection to IR emitter

5. AUDIO CONTROL

• ARC - When ARC mode is selected, an HDMI cable from the HDMI OUT should connect to an ARC

compatible input on a display, digital audio will then de-embed from the TOSLINK OUT on the DL-

HD2100 transmitter

• TOSLINK - When TOSLINK mode is selected, a Toslink cable should be connected from the displays

digital audio output to the TOSLINK IN on the DL-HD2100 receiver, digital audio will then de-embed

from the TOSLINK OUT port of the DL-HD2100 transmitter

6. RS232

• 3 pin Phoenix connector port for connecting / passing RS232 control from transmitter location

7. HDMI In

• HDMI input port for connections to video sources

8. Ethernet

• RJ45 port for passing Ethernet from transmitter

9. TOSLINK IN

• Digital audio return channel input port for injecting digital audio signal from display (only in TOSLINK

mode)