- ページ 30

無線アクセスポイント Cisco Aironet 1530のPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Aironet 1530 41 ページ。 Outdoor access points

Autonomous Mode Configuration

The 1530 Series allows the Unified (controller-based) and Autonomous mode software to be loaded at

the factory on the same hardware part number. This eliminates the need for separate part numbers for

controller-based units and autonomous mode units.

At boot-up, the default mode is controller-based. The 1530 will power up and begin searching for a

controller. Once it joins the controller, it will download the active Unified image from the controller.

This is the same operation as other Cisco controller-based APs.

For Autonomous mode, the user should take the following steps:

Power the AP and connect to the console.

Step 1

From the Command Line, enter:

Step 2

AP # capwap ap autonomous

The system will respond with "Convert to Autonomous image. Proceed? (yes/[No]):"

Step 3

Type "yes" to confirm.

Step 4

The AP will then re-boot and load the Autonomous image. The unified image is erased.

Step 5

Once the 1530 has booted in autonomous mode, configuration of the AP can done by

Step 6

following the procedure outlined here:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-

3-3.html

(# means privileged EXEC mode)