Cisco Aironet 1530 Başlangıç Kılavuzu - Sayfa 30

Kablosuz Erişim Noktası Cisco Aironet 1530 için çevrimiçi göz atın veya pdf Başlangıç Kılavuzu indirin. Cisco Aironet 1530 41 sayfaları. Outdoor access points

Sayfayı Yazdır

Autonomous Mode Configuration

The 1530 Series allows the Unified (controller-based) and Autonomous mode software to be loaded at

the factory on the same hardware part number. This eliminates the need for separate part numbers for

controller-based units and autonomous mode units.

At boot-up, the default mode is controller-based. The 1530 will power up and begin searching for a

controller. Once it joins the controller, it will download the active Unified image from the controller.

This is the same operation as other Cisco controller-based APs.

For Autonomous mode, the user should take the following steps:

Power the AP and connect to the console.

Step 1

From the Command Line, enter:

Step 2

AP # capwap ap autonomous

The system will respond with "Convert to Autonomous image. Proceed? (yes/[No]):"

Step 3

Type "yes" to confirm.

Step 4

The AP will then re-boot and load the Autonomous image. The unified image is erased.

Step 5

Once the 1530 has booted in autonomous mode, configuration of the AP can done by

Step 6

following the procedure outlined here:

http://www.cisco.com/c/en/us/td/docs/wireless/access_point/15-3-3/configuration/guide/cg15-

3-3.html

(# means privileged EXEC mode)