- ページ 3

無線アクセスポイント Cisco WAP125のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP125 14 ページ。 Wireless-ac/n dual band desktop access point with poe
Cisco WAP125 にも：クイック・スタート・マニュアル (13 ページ), マニュアル (10 ページ)

ページを印刷する

WAP125 to network devices, such as computers, routers, or switches. We strongly

recommend that you use a Category 5e or better cable for Gigabit connectivity.

POWER—The POWER button is used to turn the power on and off. It is not

applicable when using PoE.

12V DC—The 12V DC jack is used to connect the supplied power adapter to the

Cisco WAP125 if you are not using PoE.

Kensington Lock Slot—The Kensington lock slot is used to attach a cable and lock to

the Cisco WAP125.

Default Settings

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco RV Series router, the default range for the DHCP assigned

address is from 192.168.1.100 to 192.168.1.254. Any device connecting to the same

LAN will be assigned an IP address in this range.

Mounting the Cisco WAP125

You can place the Cisco WAP125 horizontally on a surface so that it sits on its four

rubber feet, or place it vertically on a desktop by using the stand on its left side.

To place the Cisco WAP125 vertically on a desktop, follow these steps:

Locate the left side panel of the Cisco WAP125, and rotate the stand 90

TEP

degrees clockwise or anticlockwise.

Place the stand upward so that the Cisco WAP125 stands on a flat desktop.

TEP

Placement Tips

• Ambient Temperature—To prevent the Cisco WAP125 from overheating, do

not operate it in an area that exceeds an ambient temperature of 104°F (40°C).

• Air Flow—Be sure there is adequate air flow around the device.

• Mechanical Loading—The Cisco WAP125 should be level, stable, and secure to

prevent it from sliding or shifting out of position.

Cisco WAP125 Quick Start Guide

Default Value

cisco

DHCP address assigned by server

192.168.1.245

255.255.255.0