Cisco WAP125 빠른 시작 매뉴얼 - 페이지 3
{카테고리_이름} Cisco WAP125에 대한 빠른 시작 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco WAP125 14 페이지. Wireless-ac/n dual band desktop access point with poe
Cisco WAP125에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (13 페이지), 매뉴얼 (10 페이지)
페이지 인쇄
WAP125 to network devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for Gigabit connectivity.
POWER—The POWER button is used to turn the power on and off. It is not
applicable when using PoE.
12V DC—The 12V DC jack is used to connect the supplied power adapter to the
Cisco WAP125 if you are not using PoE.
Kensington Lock Slot—The Kensington lock slot is used to attach a cable and lock to
the Cisco WAP125.
Default Settings
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP assigned
address is from 192.168.1.100 to 192.168.1.254. Any device connecting to the same
LAN will be assigned an IP address in this range.
3
Mounting the Cisco WAP125
You can place the Cisco WAP125 horizontally on a surface so that it sits on its four
rubber feet, or place it vertically on a desktop by using the stand on its left side.
To place the Cisco WAP125 vertically on a desktop, follow these steps:
Locate the left side panel of the Cisco WAP125, and rotate the stand 90
S
1
TEP
degrees clockwise or anticlockwise.
Place the stand upward so that the Cisco WAP125 stands on a flat desktop.
S
2
TEP
Placement Tips
• Ambient Temperature—To prevent the Cisco WAP125 from overheating, do
not operate it in an area that exceeds an ambient temperature of 104°F (40°C).
• Air Flow—Be sure there is adequate air flow around the device.
• Mechanical Loading—The Cisco WAP125 should be level, stable, and secure to
prevent it from sliding or shifting out of position.
Cisco WAP125 Quick Start Guide
Default Value
cisco
cisco
DHCP address assigned by server
192.168.1.245
255.255.255.0
3