- ページ 3

無線アクセスポイント Cisco WAP371のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco WAP371 15 ページ。 Reboot and reset to factory default settings
Cisco WAP371 にも：クイック・スタート・マニュアル (38 ページ), マニュアル (5 ページ), マニュアル (4 ページ)

ページを印刷する

Cisco WAP371 Wireless-AC/N Dual Radio

Access Point with Single Point Setup

Features

Front Panel

The front panel of the device consists of three lights: Power, WLAN, and

LAN. For full descriptions of the colors of the lights and their indications,

see

Verifying the Hardware Installation, page

A Kensington lock slot is found under the lights.

Back Panel

The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet

port to power your device using PoE. It is an auto-sensing, Gigabit

Ethernet (802.3) port used to connect your WAP devices to network

devices, such as computers, routers, or switches. We strongly

recommend that you use a Category 5e or better cable for gigabit

connectivity.

The 12V DC jack is used to connect the supplied power adapter to the

Cisco WAP371 if you are not using PoE.

The back panel of the device has a Reset button. See

Devices or Returning them to their Factory Default Settings, page 10

for information on the Reset button.

Default SettingHAF1H39Cs

Parameter

Username

Password

LAN IP Address

Fallback LAN IP

Subnetwork Mask

If you are using a Cisco RV Series router, the default range for the DHCP

assigned address is from 192.168.1.100 to 192.168.1.254. Any device

connecting to the same LAN will be assigned an IP address in this range.

Cisco WAP371 Wireless Access Point

Default Value

cisco

DHCP address assigned

by server

192.168.1.245

255.255.255.0

Rebooting the