Cisco WAP371 Hızlı Başlangıç Kılavuzu - Sayfa 3
Kablosuz Erişim Noktası Cisco WAP371 için çevrimiçi göz atın veya pdf Hızlı Başlangıç Kılavuzu indirin. Cisco WAP371 15 sayfaları. Reboot and reset to factory default settings
Ayrıca Cisco WAP371 için: Hızlı Başlangıç Kılavuzu (38 sayfalar), Manuel (5 sayfalar), Manuel (4 sayfalar)
Sayfayı Yazdır
Cisco WAP371 Wireless-AC/N Dual Radio
2
Access Point with Single Point Setup
Features
Front Panel
The front panel of the device consists of three lights: Power, WLAN, and
LAN. For full descriptions of the colors of the lights and their indications,
see
Verifying the Hardware Installation, page
A Kensington lock slot is found under the lights.
Back Panel
The back panel of the device has an RJ-45 Ethernet port. Use the Ethernet
port to power your device using PoE. It is an auto-sensing, Gigabit
Ethernet (802.3) port used to connect your WAP devices to network
devices, such as computers, routers, or switches. We strongly
recommend that you use a Category 5e or better cable for gigabit
connectivity.
The 12V DC jack is used to connect the supplied power adapter to the
Cisco WAP371 if you are not using PoE.
The back panel of the device has a Reset button. See
Devices or Returning them to their Factory Default Settings, page 10
for information on the Reset button.
Default SettingHAF1H39Cs
Parameter
Username
Password
LAN IP Address
Fallback LAN IP
Subnetwork Mask
If you are using a Cisco RV Series router, the default range for the DHCP
assigned address is from 192.168.1.100 to 192.168.1.254. Any device
connecting to the same LAN will be assigned an IP address in this range.
Cisco WAP371 Wireless Access Point
Default Value
cisco
cisco
DHCP address assigned
by server
192.168.1.245
255.255.255.0
6.
Rebooting the
2