- ページ 8

会議システム Cisco 500 SeriesのPDF トラブルシューティングとメンテナンスをオンラインで閲覧またはダウンロードできます。Cisco 500 Series 15 ページ。 Stackable managed switches
Cisco 500 Series にも：安全情報マニュアル (42 ページ), マニュアル (4 ページ), クイック・スタート・ガイド (13 ページ), クイック・スタート・マニュアル (21 ページ), データシート (5 ページ), ユーザーマニュアル (4 ページ), ユーザーマニュアル (6 ページ), ユーザーマニュアル (46 ページ), マニュアル (40 ページ), 管理マニュアル (48 ページ), マニュアル (24 ページ), クイック・リファレンス・マニュアル (7 ページ), クイック・スタート・マニュアル (25 ページ)

Wireless Battery Issues

Solution

Wireless Battery Issues

Headset Doesn't Charge

Problem

Your Cisco Headset 560 Series doesn't charge when placed on the base.

Solution

Headset Does Not Hold a Charge

Problem

The wireless headset is not holding a full charge.

Solution

Your Cisco Headset 560 Series is designed to hold its charge for up to 8 hours of continuous use. If your headset

battery seems weak or defective, contact your IT department.

You can use the Cisco Collaboration Problem Report Tool (PRT) to collect and send phone logs, and to report

problems to your administrator. The PRT also logs information about your headset. If you see a message that

the PRT upload has failed, the problem report is saved on the phone and you should alert your administrator.

Procedure

Step 1

Press Applications

Step 2

Select Phone information > Report problem.

Troubleshooting and Maintenance

Make sure the audio on your intended call device is turned up.

Make sure that the Mobile

it is selected.

Try re-pairing the multibase to your call device. Press and hold the Bluetooth button at the back of the

base for four seconds. Press the Bluetooth button twice to put the base into pairing mode and select

Cisco Headset from your call device settings menu.

Make sure that your headset is properly seated on the base. When the headset is properly seated, the

LED shows solid white. When charging, the LEDs on the base light up in sequence from left to right. When

the headset is fully charged, all five battery indicator LEDs show solid white.

Check that your base is plugged into a reliable power source.

source is selected on the base. The source LED shows solid white when

Troubleshooting and Maintenance