- ページ 14
マトリックススイッチャー Cable Electronics HSW44C PlusのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Cable Electronics HSW44C Plus 17 ページ。 4x4 hdmi matrix switch with cat5 output and up to 60khz ir
ページを印刷するMethod 3: Use IR remote control to the HSMR Plus receiver units
Step1. Press FN key first
Step2. W ait until the LED on the receiver showing "U"
Step3. T hen press the button
"1" Default A − 1080p & 7.1ch audio
"2" Default B − 1080p & stereo audio
"3" Default C − 720p & stereo audio
"4" Default D − DVI Mode
"5" Learning EDID from this display to the
selected input
Step4. I f the procedure is successful, the LED of will
show "0", otherwise it will be "F" to indicate
failure
25
Notice
1. Incorrect placement of IR Blaster and Receiver may result in the failure of the IR
extenders. Please check carefully before plugging in the IR extender to the respective IR
sockets. Warranty will not cover the damage.
2. All HDMI over CAT5 transmission distances are measured using Belden 1583A CAT5e
125MHz UTP cable and ASTRODESIGN Video Signal Generator VG-859C & VG-870B.
3. The transmission length is largely affected by the type of Cat-5/5e/6 cables, the type
of HDMI sources, and the type of HDMI display. The testing result shows solid UTP cables
(usually in the form of 300m [1,000ft] bulk cables) can transmit a lot longer signals than
stranded UTP cables (usually in the form of fixed length patch cords). Shielded STP cables
are better suited than unshielded UTP cables. A solid UTP Cat-5e cable shows longer
transmission range than stranded STP Cat-6 cable. For long extension applications, solid
UTP/STP cables are the only viable choice.
4. EIA/TIA-568-B termination (T568B) for Cat-5/5e/6 cables is recommended.
5. To reduce the interference among the unshielded twisted pairs of wires in Cat-5/5e/6
cable, one can use double shielded STP cables to improve EMI problems, which is
worsen in long transmission.
6. Because the quality of the category cables has the major effect on how long the
transmission limit can achieve and how good is the received picture quality, the actual
transmission range is subject to one's choice of Cat-5/5e/6 cables. For desired resolutions
greater than 1080i or 1280x1024, a Cat-6 cable is recommended.
7. If your HDMI display has multiple HDMI inputs, it is found that the first HDMI input [HDMI
input 1] generally can produce better transmission performance among all HDMI inputs.
8. The HSMR Plus has been tested extensively and found that it doesn't require external
power supply. If in rare situation you find it cannot work with the HSW44C Plus, please use
any +5V power adapter to plug in the power jack and see if it can work. If not, please
contact your technical support for further service.
9. Additional IR remote controls and IR blasters can be purchased as optional accessories
to control the HDMI sources located separately.
Performance Guide for HDMI over LAN Cable Transmission
Performance rating
Wiring
Shielding
Unshielded (UTP)
Solid
Shielded (STP)
Unshielded (UTP)
Stranded
Shielded (STP)
Termination
Please use EIA/TIA-568-B termination (T568B) at any time
Type of category cable
CAT5
CAT5e
CAT6
26