- ページ 7

テレビ Sony BKM-FW50のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Sony BKM-FW50 18 ページ。 Streaming receiver adaptor
Sony BKM-FW50 にも：パンフレット＆スペック (12 ページ), 取扱説明書 (28 ページ), 仕様 (2 ページ), 仕様 (12 ページ), パンフレット (4 ページ), 取扱説明書 (35 ページ)

ページを印刷する

Using slide show playback

When a CF card which contains still images

taken with a digital still camera is inserted

into the BKM-FW50, JPEG format still

image files will be automatically detected,

and the images will be shown on the

display as a slide show.

Detailed control of playback

method

When the display is connected to a network

via the BKM-FW50, any still image or

video file stored on the CF card can be

shown on the display. For information on

settings and operation in this case, see the

section "Computer Operation" (page 9).

In addition, the BKM-FW50 is set to

automatically display any still image or

video slide show saved in the

"DCIM\101MSDCF" folder, as the factory

default.

Removing the CF card

Turn power to the display off, and then

proceed as follows.

Note

Make sure to turn off the display's main

power before inserting or ejecting a CF

card. Data may be lost or damaged if a CF

card is ejected while being accessed by the

unit.

Remove the memory card slot cover

fastening screw with a Phillips

screwdriver.

Press the eject button to remove the

CF card.

Replace the memory card slot cover

and tighten the fastening screw with a

Phillips screwdriver.

Preparations for

Using the Network

Functions

The BKM-FW50 can be connected to a

network with 10BASE-T/100BASE-TX

LAN cable.

When connected to a LAN, the IP

addresses of the BKM-FW50 can be set

using one of the following two methods.

• Assigning a fixed IP address to the

BKM-FW50

Normally this method should be used.

• Automatically obtaining an IP

address

If the network to which the BKM-FW50

is connected has a DHCP server, you can

have the DHCP server automatically

assign an IP address. Note that in this

case the IP address will change every

time the display in which the BKM-

FW50 is installed is turned on.

Assigning a fixed IP address

to the BKM-FW50

Note that a separate IP address is necessary

for the display control function and for the

still image/video playback function.

Regarding details of IP address selection,

consult your network administrator.

Setting an IP address for the

display control function

First, assign an IP address to the display

control function, using the following

procedure. The IP address assigned in this

way is used for calling the display control

function of the BKM-FW50 from a

computer on the network. Also consult the

operating instructions of the display.

Connect the BKM-FW50 installed in

the display to the network, using

suitable LAN cable.

Turn power to the display on and

wait for about 30 seconds.