- ページ 16

ウェザーステーション ACU-RITE Iris 06014のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。ACU-RITE Iris 06014 20 ページ。 (5-in-1) weather sensor (dual solar panel)

ページを印刷する
Programmable Alarms
This display features programmable alarms that sound an alert to notify you when a value (for
outdoor temperature, humidity, wind speed or rainfall) has been reached or exceeded. When an
alarm is triggered, the display emits an audible beep and flashes data in the affected category. You
can customize the alarms by turning ON or OFF the alarms you'd like activated or deactivated, and
by inputting your own values to trigger the alarm.
Setup an Alarm
1.
Press and release the "
shown on the display. "
2.
Press and release the " " or " " buttons until " " appears.
3.
Press and release the " SET " button. The current alarm value will flash on the display.
4.
Press and release the " " or " " buttons to adjust the alarm's value.
5.
Press and release the "
6.
Press and release the "
Disable an Alarm
1.
Press and release the "
shown on the display. " " will be shown.
2.
Press and release the " " or " " buttons until "
3.
Press and release the "
4.
Repeat steps 1-3, as needed.
NOTE: To disable ALL alarms at once, press and HOLD the "
You will automatically exit alarm SET MODE if no buttons are pressed for 10 seconds. Enter alarm
SET MODE at any time by pressing the "
Care & Maintenance
Display Care
Clean with a soft, damp cloth. Do not use caustic cleaners or abrasives. Keep away from dust, dirt
and moisture. Clean ventilation ports regularly with a gentle puff of air.

Calibration

The outdoor temperature and humidity, indoor temperature, and barometric pressure can be
calibrated on the display to improve accuracy. Calibration can improve accuracy when sensor
placement or environmental factors impact the data accuracy.
1. To access calibration mode, press " ", "SET" and " " buttons simultaneously for at least 5 seconds.
2. To adjust the currently selected (flashing) item, press and release the " " or " " buttons to
calibrate the data value higher or lower from the actual reading.
3. To save your adjustments, press and release the "SET" button to adjust the next preference. The
"
" icon will remain illuminated next to calibrated values.
The preference set order is as follows:
OUTDOOR TEMPERATURE
OUTDOOR HUMIDITY
INDOOR TEMPERATURE
*To change from AUTO to MANUAL pressure mode and vice versa, press AND HOLD the "SET" button
for at least 10 seconds. The display indicates the current pressure mode selected,"AUTO" or "MANUAL".
After 20 seconds of inactivity, the display will save the adjustments and exit calibration mode.
NOTE: Calibrations will be erased if the display is reset or if batteries are removed.
" button until the reading for which you wish to set an alarm is
" will be shown.
" button to save the alarm value.
" button to cycle to the next reading.
" button until the reading for which you wish to disable an alarm is
" button to cycle to the next reading.
" button.
BAROMETRIC PRESSURE
(must be set to MANUAL mode to calibrate)*
8
" appears.
" button for 10 seconds.