- ページ 44

会議システム Cisco UC500 seriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco UC500 series 50 ページ。 Sip trunking unified communications 500 series

dial-peer voice 11100 voip

corlist outgoing call-fax

description ** Outgoing fax call to SIP trunk **

translation-profile outgoing PSTN_Outgoing

answer-address 301

destination-pattern 9T

session protocol sipv2

session target sip-server

dtmf-relay rtp-nte

codec g711ulaw

no vad

dial-peer voice 11101 voip

description *****Incoming Fax call from SIP Trunk *****

session protocol sipv2

session target sip-server

incoming called-number 4085551010

dtmf-relay rtp-nte

codec g711ulaw

no vad

ephone-dn 5 dual-line

number 301 secondary 4085551010 no-reg both

corlist incoming call-fax

4.4.4.3 For modem support – the UC500 supports G.711 upspeed via proprietary

methods – support is being added to Cisco IOS to upspeed to G.711 via a SIP re-

Invite as proposed in SIPConnect forum.

4.4.5 Outbound proxy support

This feature allows the UC500 to send all SIP packets to a specific IP address or DNS

instead of the IP / DNS of the proxy server defined in section 4.3.20. This is a common

method used in case the SP has an SBC (Session Border Controller) which interfaces

with all customer IP PBXes from the SP point of view.

voice service voip

sip

outbound-proxy dns:sipconnect.cisco.com

Note: If outbound proxy is used, you cannot use SIP phones (such as Cisco 3911 or

3951) till UC520 software pack is upgraded to 4.3.x. Also, since the interface between

UC500 & CUE (voicemail / AA) is also SIP – make sure all VOIP dial-peers on UC500

pointing to CUE have the below added:

dial-peer voice 2000 voip

description ** cue voicemail pilot number **

voice-class sip outbound-proxy ipv4:10.1.10.1

4.4.6 Call Admission Control (CAC) & QoS

Since calls over SIP Trunk are using the IP interconnect, there is no implicit CAC setup

like you would have with TDM trunks such as timeslots on a T1 PRI. To allow for this