- ページ 3

エアコン Argo SDIBS9DCのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo SDIBS9DC 15 ページ。 Split air conditioner system
Argo SDIBS9DC にも: 取付説明書 (19 ページ), 取扱説明書 (17 ページ)

nAME oF PARtS AnD oPERAtIon SELECtoR SWItCh

5
6
1. Remote control unit.
2. Remote control sensor: Detects the room temperature
around the remote control unit, the air conditioner is
controlled accordingly.
3. Air outlet: Conditioned air is blown out of the air
conditioner through the air outlet.
4. Air intake: Air from the room is drawn into this section
and passes through air filter which removes dust.
5. Remote control receiver: This section picks up infrared
signals from the remote control unit (Transmitter).
6. operation selector (without remote control): Push
the button to walk through the operation modes (OFF,
COOL and HEAT)
WARnInG
the oFF position does not disconnect the power. Use
the main power switch to turn off power completely.
7. oPERAtIon lamp: This lamp lights up during
operation.
It blinks once to announce that the remote control
signal has
been received and stored.
8. StAnDBY lamp: This lamp lights up when the air
conditioner is connected to the power and ready to
receive the remote control command.
9. tIMER lamp: This lamp lights up when the system is
being controlled by the timer.
10. Air filter.
11. Condensate drain connection.
notA
When the unit receives a signal from the remote
controller, all the three lamps (oPERAtIon, tIMER
and StAnDBY) light up for a moment to indicate the
correct signal reception.
3
4
10
oFF LAMPS FUntIon
It is possible to set the air conditioner in order to let the
OPERATION, TIMER and STANDBY lamps always OFF,
even during operation.
Be sure that the remote controller is ON (using the ON/
OFF button) and that the symbol
remote controller is OFF, then Press contemporary the
IFEEL and FAN buttons on the remote control unit for more
then 5 seconds.
Repeat the same procedure to set again the normal
operation conditions.
If the air conditioner is powered, but the lamps are off, try
to activate them using this procedure.
In case of troubleshooting the air conditioner diagnostic
system activates the lamps accordingly, even if they are
set to OFF. See paragraph TROUBLESHOOTING for
further details.
MULtI SPLIt SYStEM only
the blinking of tIMER and StAnDBY lamps and
oPERAtIon lamp on, indicates that:
1. Indoor unit has not been addressed.
2. heating mode has been selected, when the system
was in cooling mode, or vice versa.
Select the correct mode, compatible with the
system.
SEE AUto-DIAGnoSIS tABLE
3
11
2
1
7 8 9
EG
on the display of