Argo SDIBS9DC Руководство по эксплуатации - Страница 3

Просмотреть онлайн или скачать pdf Руководство по эксплуатации для Кондиционер Argo SDIBS9DC. Argo SDIBS9DC 15 страниц. Split air conditioner system
Также для Argo SDIBS9DC: Руководство по установке (19 страниц), Руководство по эксплуатации (17 страниц)

Печатать страницу

nAME oF PARtS AnD oPERAtIon SELECtoR SWItCh

1. Remote control unit.

2. Remote control sensor: Detects the room temperature

around the remote control unit, the air conditioner is

controlled accordingly.

3. Air outlet: Conditioned air is blown out of the air

conditioner through the air outlet.

4. Air intake: Air from the room is drawn into this section

and passes through air filter which removes dust.

5. Remote control receiver: This section picks up infrared

signals from the remote control unit (Transmitter).

6. operation selector (without remote control): Push

the button to walk through the operation modes (OFF,

COOL and HEAT)

WARnInG

the oFF position does not disconnect the power. Use

the main power switch to turn off power completely.

7. oPERAtIon lamp: This lamp lights up during

operation.

It blinks once to announce that the remote control

signal has

been received and stored.

8. StAnDBY lamp: This lamp lights up when the air

conditioner is connected to the power and ready to

receive the remote control command.

9. tIMER lamp: This lamp lights up when the system is

being controlled by the timer.

10. Air filter.

11. Condensate drain connection.

notA

When the unit receives a signal from the remote

controller, all the three lamps (oPERAtIon, tIMER

and StAnDBY) light up for a moment to indicate the

correct signal reception.

oFF LAMPS FUntIon

It is possible to set the air conditioner in order to let the

OPERATION, TIMER and STANDBY lamps always OFF,

even during operation.

Be sure that the remote controller is ON (using the ON/

OFF button) and that the symbol

remote controller is OFF, then Press contemporary the

IFEEL and FAN buttons on the remote control unit for more

then 5 seconds.

Repeat the same procedure to set again the normal

operation conditions.

If the air conditioner is powered, but the lamps are off, try

to activate them using this procedure.

In case of troubleshooting the air conditioner diagnostic

system activates the lamps accordingly, even if they are

set to OFF. See paragraph TROUBLESHOOTING for

further details.

MULtI SPLIt SYStEM only

the blinking of tIMER and StAnDBY lamps and

oPERAtIon lamp on, indicates that:

1. Indoor unit has not been addressed.

2. heating mode has been selected, when the system

was in cooling mode, or vice versa.

Select the correct mode, compatible with the

system.

SEE AUto-DIAGnoSIS tABLE

7 8 9

on the display of