- ページ 10

ネットワーク・ハードウェア Cisco 7513 SeriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 7513 Series 30 ページ。 Chassis replacement
Cisco 7513 Series にも：クイック・スタート・マニュアル (44 ページ), 交換取扱説明書 (26 ページ), データシート (11 ページ), 維持 (20 ページ), 交換取扱説明書 (19 ページ), 交換取扱説明書 (22 ページ)

Chassis Replacement or Upgrade Prerequisites

•

When removing any cable, pull the cable out at the connector; never pull or tug on the cable itself.

For detailed descriptions of the system components, refer to the Cisco 7500 Series Installation and

Conﬁguration Guide.

Preparing the Work Area

Although some network downtime is unavoidable while you remove the RSPs from the old chassis,

and replace them in the new chassis, you can minimize the downtime by placing the old and new

chassis close together. If your existing chassis is mounted in a rack and there is space in the same

rack or another rack close by, we recommend that you install the new, empty chassis in the rack

before moving the components. (A fully conﬁgured chassis weighs approximately 160 pounds.)

Before installing the chassis in a new rack location, ensure that routing the interface cables to the

new positions will not strain or tangle them.

You can further minimize downtime by leaving interface cables attached when you move interface

processors to the new chassis, provided that doing so will not strain the cables.

Leave network interface cables connected to the interface ports only if the following conditions are

true:

•

Note

before you can install the new chassis, you must disconnect all power and network interface cables.

Ensure that your new chassis allows sufﬁcient clearance for maintenance—to remove and replace

processor modules, the blower module, and interface cables at the interface processor end, and to

access the internal components at the noninterface processor end.

Figure 4 shows the chassis footprint and the clearance required.

10 Cisco 7513 and Cisco 7576 Chassis Replacement and Upgrade Instructions

Ethernet interface cables use either slide-type locks or thumbscrews. Although all Ethernet

Interface Processors (EIPs) ship from the factory with slide-type locks on each port, all EIPs also

include conversion kits for replacing the slide-type locks with jackscrews to accommodate

Ethernet interface cables with thumbscrews.

Multimode, FDDI connectors use small plastic arms on two sides of the connector that act like

springs and are constrained by the inside of the connector port. To remove a multimode cable

from an FDDI Interface Processor (FIP) port, pinch the two plastic arms inward while pulling the

connector out of the port.

You are able to place the new chassis close to the existing chassis, and moving the processor

modules to the new chassis will not strain the interface cables.

The new chassis is already located in its permanent location, or you will need to move it only a

few feet into the space vacated by the old chassis when it is removed.

If these conditions are not true, for instance, if you must remove a rack-mounted chassis