- ページ 5

除湿機 Argo DRY BABY 11のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo DRY BABY 11 8 ページ。
Argo DRY BABY 11 にも：取扱説明書 (6 ページ), 取扱説明書 (10 ページ)

WARNING:

After each interruption of its operation, at least 3 minutes must pass before the dehumidifier starts up again:

this delay prevents the compressor being damaged.

If, on the other hand, the set humidity percentage is higher than the level currently found in the room, the

dehumidifier will not start.

If you follow the start up instructions but the dehumidifier does not start and the stand by led (Dry Baby 11) or display

(Dry Digit 13 and 17) does not come on, or if the dehumidifier stops for no reason, make sure the plug and power cord

are in good working order. After doing so, wait for 10 minutes and then restart the appliance.

If the dehumidifier still does not start after 10 minutes, or if either the power cord or plug are damaged, switch off the

appliance and contact an after-sales service centre.

WARNING:

When the dehumidifier is running, the compressor produces heat and the appliance emits warm air into the

room. The room temperature will therefore tend to increase. This is completely normal.

TURNING THE DEHUMIDIFIER OFF

To turn the dehumidifier off, turn the humidity knob counterclockwise to OFF (Dry Baby 11), see from the front, or press

the ON/OFF button (Dry Digit 13 and 17). This shuts off power to the unit.

Unplug the appliance if you do not intend to use it for some time.

HOW TO ELIMINATE CONDENSATION

The water extracted from the air can be collected in the provided front tank.

When the tank is full, the unit turns off. The FULL TANK led turns on and the unit beeps for about 10 seconds. Empty

the tank. Use two hands to empty the tank.

CONTINUOUS CONDENSATE DRAINAGE

You can fit a 14 mm internal diameter PVC hose (not included) to drain the tank continuous.

Remove the drain hole cap by turning

it counterclockwise.

Remove the rubber plug.

V 09/16

Screw the drain hose fitting (included)

into the drain hole.

Connect a PVC hose (not supplied) to

the drain hole.

Connect the hose to water drain.