- ページ 6

除湿機 Argo DRY BABY 11のPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Argo DRY BABY 11 8 ページ。
Argo DRY BABY 11 にも：取扱説明書 (6 ページ), 取扱説明書 (10 ページ)

DRY BABY 11 CONTROL PANEL

DEFROST LED

TANK FULL

LED

HUMIDITY ADJUSTER KNOB: sets the desired humidity %. Turn the knob fully counterclockwise (seen from in front of

the appliance), to turn the appliance OFF.

Turn the knob clockwise (seen from in front of the appliance) to set the humidity % (decreasing)(80-35%).

TANK FULL LED: when the tank is full, the TANK FULL LED comes on and the appliance stops running. A 10 second

beep sounds. Remove the tank and empty it (as indicated in "HOW TO ELIMINATE CONDENSATION"), the restore it;

the dehumidifier will start running again.

STAND BY LED.

DEFROST LED: the dehumidifier is designed to operate at ambient temperatures from + 5°C to + 35°C.

If it is operated at low temperatures, ice may form on the evaporator, degrading its operation.

When this happens the dehumidifier goes into defrost mode and the defrost LED comes on. The compressor stops, but the

fan continues running.

We recommend not using the dehumidifier in room temperatures lower than 5°C.

AUTO RESTART: the dehumidifier starts up again after a power failure.

DRY DIGIT 13 AND 17 CONTROL PANEL

LOW AND HIGH FAN

SPEED

TIMER LED

STAND BY LED

1. ON/OFF BUTTON: press this button to turn the dehumidifier on and off.

2. FILTER BUTTON

after 250 hours of operation, the FILTER RESET led turns on to indicate that it is time to clean the

filter. Take the filter out and clean it. Then press the FILTER button.

V 09/16

HUMIDITY ADJUSTER KNOB

STAND BY LED

TANK FULL LED

CONTINUOUS OPERATION

FILTER RESET LED