- ページ 11

デジタルカメラ Sony 6116.12 RX100 IIIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Sony 6116.12 RX100 III 32 ページ。 Digital housing (dsc-rx100m3/b)

STEP 5 - Installing Camera in the Housing

1. Pull out on each housing control until it stops. This will get the controls

out of the way for installation of the camera.

2. Remove camera lanyard from camera if attached.

3. Place the Housing Front face down in your lap.

4. Extend the built-in camera flash before placing camera in housing.

5. Gently guide the Housing Back with camera attached into the Housing

Front at a slight angle so the Control Ring Gear and Housing Gear

engage properly. Visually check to see that the Gears are properly

engaged.

CAUTION: DO NOT allow the flash to bump into the housing's main

o-ring sealing surface or the housing top during installation. This could

cause the flash to be damaged or not extend properly in the housing.

1. Once the back is properly

installed, the o-ring should touch

the housing all the way around.

There should be an even gap on

each side of the housing between

the housing and the back.

2. Lift the lid snaps so they are

extended and place each lid snap

into the corresponding hook on

the housing back.

3. To close the housing, push down on

the opposing lid snaps simultaneously

until they snap into place. Be sure

they are down far enough to engage

the Lid Snap Lock. The o-ring seal

should now appear as a solid black

line from the back of the housing.

Lid Hook

Even gap on

all four sides

Lid

Snap

Lid Snap Lock

Housing Back

O-ring