- ページ 5
デジタルカメラ Sony TS-DSC-P41-01のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Sony TS-DSC-P41-01 12 ページ。 Sony camera tracksnap manual
ページを印刷するTrackSnap Manual
The 10-Position DIP switch on the PixController board is used to setup how the board controls the attached
cameras, functions in day only, night only, 24 hour mode, and many more features. Listed below are
instructions on how to setup the DIP switch feature on the LE board.
The default settings for your camera are marked in Yellow
All switches Down (Off) except SW6 and SW10 Up (ON) and a summary is listed:
10 Sec PIR Delay
24 hour mode of operation
Sony P32/P41 Camera
Continuous movement movie setting
Green PIR LED ON
Switches 1 and 2 control the delay between PIR events. This setting is used so you can limit or not limit the
number of photos taken when a motion event triggers your board. For example when you set your system up
on a track you will want the 10 second delay setting so you can capture as many photos as possible, but when
setup over a feeder you want to use the 10 minute PIR delay so you limit the number of photos of one animal.
PIR Delay
10 Seconds
2 Minutes
5 Minutes
10 Minutes
Switches 2 and 3 control the mode of operation of your PixController board. Here you can setup if the board is
to function 24 hours a day, night only, or day only. The last setting sets up the day/night sensor light detection
level. This is useful for setting up your PixController board to detect light/darkness levels.
Mode
24 Hour Operation
Night Only
Day Only
Day/Night Sensor Calibration.
Version
TS P41.2
This document comprises information provided by Suppliers and is
PixController 10-Position DIP Switch
Switch 3
Down/Off
Down/Off
Up/On
Up/On
Page 5 of 12
assumed to be correct.
Model TS-DSC-P41-01
Switch 1
Down/Off
Down/Off
Up/On
Up/On
Switch 2
Down/Off
Up/On
Down/Off
Up/On
Switch 4
Down/Off
Up/On
Down/Off
Up/On
Released