デジタルカメラ Sony XDCAM EX PMW-EX3のPDF はじめにをオンラインで閲覧またはダウンロードできます。Sony XDCAM EX PMW-EX3 9 ページ。 Solid-state memory camcorder
Sony XDCAM EX PMW-EX3 にも：パンフレット＆スペック (35 ページ), パンフレット (24 ページ), パンフレット＆スペック (6 ページ), パンフレット＆スペック (35 ページ), サービスマニュアル (24 ページ), 使用方法 (2 ページ)

ページを印刷する

Getting Started

Overview

This document describes how to use the XDCAM EX

Version Up Tool (hereafter "Version Up Tool") to

upgrade the PMW-EX1 and PMW-EX3. Use a USB cable

to connect the PMW-EX1/EX3 to a computer with the

XDCAM EX Version Up Tool installed, and perform the

upgrade from the computer.

Note

The USB connector used for the upgrade is a dedicated

connector for upgrade only.

See "Connecting the Computer and PMW-EX1/EX3"

(page 1) for details.

Refer to the PMW-EX1 or PMW-EX3 Operating

Instructions for details on using the PMW-EX1/EX3.

To check the current version

To display the version, select "Version" from the

OTHERS menu.

If your current version is 1.00 or more, you can use the

Version Up Tool to upgrade to the latest version.

Version Up Tool system requirements

Hard Disk Space

Approx. 50 MB

OS/CPU

Windows

The 32 bit and 64 bit

versions of the

following OS

• Microsoft Windows

XP (Service Pack3

or later)

• Microsoft Windows

Vista (Service Pack2

or later)

• Microsoft Windows 7

CPU Intel x86 architecture

CPU

(Excluding Itanium

CPUs)

a) Microsoft .NET Framework 3.5 or higher must be installed.

Mac

The 32 bit version of the

following OS

• Mac OS X v10.4 (Tiger)

• Mac OS X v10.5

(Leopard)

• Mac OS X v10.6 (Snow

Leopard)

Intel x86 architecture CPU

(Excluding PowerPC

CPUs)

PMW-EX1/PMW-EX3

* Microsoft, Windows, Windows Vista, and Windows 7 are registered

trademarks of Microsoft Corporation in the United States and other

countries.

Notes on performing upgrade

• If you are using a Windows computer, you must have

the standard device driver supplied with Windows.

• If the computer's OS is Windows Vista or Windows 7,

then you must have administrator privileges.

• If the computer's OS is Windows XP, then the

Microsoft .NET Framework runtime is required.

• Only connect one PMW-EX1/EX3 camcorder to the

computer for upgrade.

• Use the BC-U1/U2 Battery Charger to connect the

PMW-EX1/EX3 to an AC power source. You can

mount the battery pack at the same time to prevent

problems in case the AC power source is interrupted.

• If you interrupt the upgrade process, you must start over

from the beginning. You cannot interrupt the process

after installing some of the modules, and then resume

the process where you left off.

Connecting the Computer and

PMW-EX1/EX3

To connect a PMW-EX1

Rotate the grip with the RELEASE button pressed

down as shown in the figure below.

O F F

M E D

D C

O U T

A /V

M W

- E X

O U T

S D I

RELEASE

RELEASE button

E N T

P O N

C O M

O U T

Grip

4-187-922-13 (1)