- ページ 3

ネットワーク・ハードウェア Cisco ATA 191のPDF 管理マニュアルをオンラインで閲覧またはダウンロードできます。Cisco ATA 191 4 ページ。 Analog telephone adapter
Cisco ATA 191 にも：ユーザーマニュアル (30 ページ), ユーザーマニュアル (10 ページ), スタート (8 ページ), マニュアル (10 ページ), クイック・スタート・マニュアル (13 ページ), セットアップマニュアル (6 ページ), ユーザーマニュアル (40 ページ), ユーザーマニュアル (30 ページ)

Install the ATA 191

Procedure

Step 1

Connect the power supply to the Cisco DC Adapter port.

Step 2

Connect a straight-through Ethernet cable from the network to the network port on the ATA. Each ATA ships

with one Ethernet cable in the box.

Attach a Phone to the ATA 191

Before You Begin

You can attach one or two phones to an ATA 191.

Procedure

Connect one or more phones to a phone port of the ATA with an RJ11 cable.

The PHONE1 and PHONE2 LEDs on the ATA light as solid green when there is activity on that port.

Startup Process Verification

After your ATA has power connected to it, it begins the startup process by cycling through these steps:

1 The Power LED flashes during the startup process.

2 The Problem Report Tool (PRT) LED lights solid amber during initial bootup. The LED then flashes

amber and then green while the application and kernel are booting.

If the PRT LED lights red during bootup, then either the MIC certificate failed, or the ATA failed to obtain

a network address.

3 The LED for Phone 1 flashes while the Phone1 port boots, followed by the LED for Phone 2.

After the Phone1 and Phone2 ports register with Cisco Unified CM successfully, the corresponding LEDs

are lit with solid green. If a phone port fails to register, the LED rapidly flashes in green three times, then

repeats.

4 When the ATA has successfully booted, the Power LED lights solid green and the PRT LED turns off.

The Network LED flashes as traffic is detected.

When you go offhook on the phone, the phone LED begins to flash, and you hear the dial tone. The ATA has

completed the startup process.