- ページ 18
ネットワーク・ハードウェア Cisco Catalyst 3560-E SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Catalyst 3560-E Series 25 ページ。 Switches and power supply modules
Cisco Catalyst 3560-E Series にも： 製品情報 (5 ページ), 質問と回答 (3 ページ), 製品サポート速報 (2 ページ), 製品サポート速報 (5 ページ), インストレーション・ノート (20 ページ)
ページを印刷する
Install and Connect to Devices in the 10-Gigabit Ethernet Slots
The switch 10-Gigabit Ethernet module slots are used for connections to other switches and routers.
The module slots operate in full-duplex mode and use the hot-swappable Cisco X2 transceiver modules
and the Cisco TwinGig Converter Module. The X2 transceiver modules have SC connectors to connect
to multimode fiber (MMF) and single-mode fiber (SMF) cables. The Cisco converter modules have two
SFP-module slots that convert the 10-Gigabit interface into a dual SFP interface.
For switches with horizontal 10-Gigabit Ethernet module slots, position the module face up to install
in the upper module slot (slot 1). Position the module face down to install in the lower module slot
(slot 2).
For switches with vertical 10-Gigabit Ethernet module slots, position the module top facing right to
install in a vertical module slot.
45
46
t 35 60 -E
When you install or remove the Cisco TwinGig converter module, the mode on the switch changes
from 10-Gigabit Ethernet to Gigabit Ethernet or the reverse. During this mode change, data traffic on
the other switch uplink ports (X2 transceiver or SFP module ports) might temporarily stop. When you
install or remove an X2 transceiver or SFP modules, traffic delay does not occur.
Use only Cisco X2 transceiver modules, Cisco converter modules, and Cisco SFP modules with the
switch. Each Cisco module has an internal serial EEPROM that is encoded with security information.
This encoding provides a way for Cisco to identify and validate that the module meets the
requirements for the switch.
18
47
48
47 X
49
X2 -1
50
X2 -2
51
48 X
SE RIE S
Po E- 48
52
21
23
X2 -1 1
X2 -1 2
22
24