- ページ 21

ネットワーク・ハードウェア Cisco Catalyst 3560-E SeriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco Catalyst 3560-E Series 25 ページ。 Switches and power supply modules
Cisco Catalyst 3560-E Series にも： 製品情報 (5 ページ), 質問と回答 (3 ページ), 製品サポート速報 (2 ページ), 製品サポート速報 (5 ページ), インストレーション・ノート (20 ページ)

ページを印刷する
Cisco Catalyst 3560-E Series スタートマニュアル

Resetting the Switch

This section describes how to reset the switch by rerunning Express Setup. These are reasons why you
might want to reset the switch:
• You installed the switch in your network and cannot connect to it because you assigned the
incorrect IP address.
• You want to clear all configuration from the switch and assign a new IP address.
• You are trying to enter Express Setup mode, and the switch LEDs start blinking when you press
the Mode button (which means that the switch is already configured with IP information).
Caution
Resetting the switch deletes the configuration and reboots the switch.
To reset the switch:
• Press and hold the Mode button. The switch LEDs begin blinking after about 3 seconds. Continue
holding down the Mode button. The LEDs stop blinking after 7 more seconds, and then the switch
reboots.
The switch now behaves like an unconfigured switch. You can enter the switch IP information by using
Express Setup as described in the "Running Express Setup" section on page 4.

Accessing Help Online

First look for a solution to your problem in the troubleshooting section of the hardware installation
guide or the software configuration guide on Cisco.com. You can also access the Cisco Technical
Support and Documentation website for a list of known hardware problems and extensive
troubleshooting documentation.
21