- ページ 15
ネットワーク・ハードウェア Cisco Firepower 4100 SeriesのPDF 製品マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 4100 Series 17 ページ。 Rack-mount and ground the chassis
Cisco Firepower 4100 Series にも： マニュアル (8 ページ), メンテナンスとアップグレードマニュアル (20 ページ), マニュアル (36 ページ), マニュアル (8 ページ), マニュアル (42 ページ), マニュアル (38 ページ)
ページを印刷する
Installation and Configuration
Connecting Access Points
After you have installed and configured the controller, use CAT-5, CAT-5e, CAT-6, or CAT-7 ethernet
cables to connect the access points to the network (Distribution System) as shown in the following
figure.
As soon as the controller is activated, it starts to scan for access points on all connected ports. When it
Note
detects an access point, it records its MAC address in its database. The Radio Resource Management
(RRM) function then automatically configures the access point to start transmitting and start allowing
clients to connect through the access points.
Figure 8
Where to Go from Here
You have completely installed the controller hardware.
•
•
•
78-17155-01
Access Points Connected to a Controller
Network
Access Points
Register your controller.
Refer to the Configuring the Cisco Wireless LAN Controllers in the Product Guide for more
information on configuring the controller.
Refer to the Product Guide for more information on configuring, operating, maintaining and
troubleshooting the controller.
Cisco 4100 Series Wireless LAN Controllers - Installation and Configuration Guide
Cisco Wireless
LAN Controller
Cisco 1000
Connecting Access Points
15