- ページ 23

ネットワーク・ハードウェア Cisco Firepower 4110のPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 4110 26 ページ。 Rack-mount and ground the chassis
Cisco Firepower 4110 にも：メンテナンスとアップグレードマニュアル (20 ページ), マニュアル (36 ページ), マニュアル (8 ページ), マニュアル (42 ページ), はじめに (42 ページ)

Installation, Maintenance, and Upgrade

• #1 Phillips screwdriver

• The following items from the FIPS kit:

• The following items from the Firepower 4100 series accessory kit:

Step 1

Copy the serial number on a label and attach it to the chassis where it can be retrieved easily for future use if needed.

To find the serial number, see

Step 2

Pull the chassis out of the rack until the release latches catch.

Step 3

If you have not already done so, attach a slide rail locking bracket to each side of the chassis using the six 8-32 x

0.375-inch Phillips screws provided in the accessory kit.

You should have completed this step while preforming the procedure described in

Note

Figure 15: Attach the Slide Rail Locking Bracket to the Side of the Chassis

Chassis

• One FIPS opacity shield

• Four 8-32 x 0.375-inch screws used to attach the FIPS opacity shield to the cable management

brackets

• 15 tamper-evident labels (TELs)

• Two cable management brackets

• Four 8-32 x 0.375-inch screws used to attach the cable management brackets to the slide rail locking

brackets

Serial Number

Location.

Slide rail locking bracket

Installation, Maintenance, and Upgrade

Install the FIPS Opacity Shield

Rack-Mount the

Chassis.