- ページ 9

ネットワーク・ハードウェア Cisco PIX 501のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco PIX 501 20 ページ。 Data sheet
Cisco PIX 501 にも：クイック・スタート・マニュアル (20 ページ), データシート (8 ページ), クイック・スタート・マニュアル (21 ページ), クイック・スタート・マニュアル (18 ページ)

PDM version 2.0 and higher releases include a Startup Wizard for initial configuration. Follow these steps

to load PDM and use the Startup Wizard:

Use an Ethernet cable to connect your PC to one of the four switched inside ports (numbered

Step 1

1 through 4) on the rear panel of the PIX Firewall.

Configure your PC to use DHCP (to receive an IP address automatically from the

Step 2

PIX Firewall) or assign a static IP address to your PC by selecting an address out of the

192.168.1.0 network.

The inside interface of the PIX Firewall is assigned 192.168.1.1, so choose a different

Note

IP address.

Check the LINK LED to verify that your PC has basic connectivity to the PIX Firewall on one

Step 3

of the inside ports (1 through 4). When connectivity occurs, the LINK LED on the front panel

of the PIX Firewall lights up solid green.

To access the Startup Wizard, use a PC connected to one of the PIX Firewall switch ports and enter

Step 4

the URL https://192.168.1.1/startup.html into your browser

It is very important to enter the "s" in "https://192.168.1.1," which indicates

Note

a secure connection. If you enter "http://192.168.1.1" without the "s" in

"https," you cannot access the PIX Firewall.

Accept the certificates and follow the instructions in the Startup Wizard. For online help, click

Step 5

the Help button at the bottom of the Startup Wizard window.