- ページ 5

ネットワーク・ハードウェア Cisco PIX-515EのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco PIX-515E 42 ページ。 Security appliance
Cisco PIX-515E にも：クイック・スタート・マニュアル (42 ページ)

ページを印刷する

Configure the PIX 515E

The PIX 515E comes with a factory-default configuration that meets the needs of most small and

medium business networking environments. A default DHCP server address pool is included for hosts on

the inside interface. The factory-default configuration on the PIX 515E protects your inside network

from unsolicited traffic.

By default, the PIX 515E denies all inbound traffic through the outside interface. Based on your

network security policy, you should also consider configuring the PIX 515E to deny all ICMP traffic

to the outside interface, or any other interface you deem necessary, by entering the icmp command.

For more information about the icmp command, refer to the

The PIX 515E contains an integrated web-based configuration

tool called the Cisco PIX Device Manager (PDM), that is

designed to help you set up the PIX Firewall. PDM is

preinstalled on the PIX 515E. To access PDM, make sure that

JavaScript and Java are enabled in your web browser. Refer to

the

Cisco PIX Device Manager Installation Guide

information on the operating system and web browser

environments supported by PDM.

PDM includes a Startup Wizard for simplified initial

configuration of your PIX Firewall. With just a few steps, the

PDM Startup Wizard enables you to efficiently create a basic configuration that allows packets to flow

through the PIX Firewall from the inside network to the outside network securely. Follow these steps to

use the Startup Wizard:

If you have not already done so, connect the inside Ethernet 1 interface of the PIX 515E to a

Step 1

switch or hub using the Ethernet cable. To this same switch, connect a PC for configuring the

PIX 515E.

Configure your PC to use DHCP (to receive an IP address automatically from the PIX 515E)

Step 2

or assign a static IP address to your PC by selecting an address out of the 192.168.1.0

network. (Valid addresses are 192.168.1.2 through 192.168.1.254 with a mask of 255.255.255.0

and default route of 192.168.1.1.)

The inside interface of the PIX 515E is assigned 192.168.1.1 by default, so this

Note

address is unavailable.

Check the LINK LED on the PIX 515E Ethernet 1 interface. When connectivity occurs, the

Step 3

LINK LED on the Ethernet 1 interface of the PIX Firewall and the corresponding LINK LED on

the switch or hub lights up solid green.

Cisco PIX Firewall Command

for more

Reference.