- ページ 6

サーバー Cisco 2500 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2500 Series 19 ページ。 Wireless controller
Cisco 2500 Series にも：設置マニュアル (12 ページ), 配備マニュアル (23 ページ), 設定マニュアル (50 ページ), スタートマニュアル (47 ページ)

ページを印刷する

1. Configuring the Global Parameters

Configuring the Access Server

Note

administrator or consult your network plan to determine correct addresses before you can

complete the access server configuration. For details on network addressing, see the

appendix "Internetworking Primer."

Before continuing the configuration process, check the current state of the access server by

entering the show version command. The show version command will display the release

of Cisco IOS software that is available on the access server.

Configuring the Access Server Using the Configuration Mode

You can configure the access server manually if you prefer not to use the setup facility or

AutoInstall. Take the following steps to configure the access server manually:

Step 1

Step 2

Step 3

Step 4

4-6 Cisco 2500 Series Access Server User Guide

You will need to acquire the correct network addresses from your system

Connect a console terminal by following the instructions described in the section

"Connecting the Console Terminal and Modem" in the chapter "Installing the

Cisco 2500 Series Access Server" and then power up the access server.

When you are asked if you would like to enter the initial dialog, answer no to go

into the normal operating mode of the access server:

Would you like to enter the initial dialog? [yes]: no

After a few seconds you will see the user EXEC prompt (Router>). Type enable

to enter enable mode. Configuration changes can only be made in enable mode:

Router> enable

The prompt will change to the privileged EXEC prompt:

router#

Enter the command config terminal at the enable prompt to enter configuration

mode from the terminal:

router# config terminal