Cisco 2500 Series Руководство по конфигурации - Страница 6
Просмотреть онлайн или скачать pdf Руководство по конфигурации для Сервер Cisco 2500 Series. Cisco 2500 Series 19 страниц. Wireless controller
Также для Cisco 2500 Series: Руководство по установке (12 страниц), Руководство по развертыванию (23 страниц), Руководство по конфигурации (50 страниц), Руководство по началу работы (47 страниц)
![Cisco 2500 Series Руководство по конфигурации](/uploads/products/server2/586124/586124.jpg)
Configuring the Access Server
Note
administrator or consult your network plan to determine correct addresses before you can
complete the access server configuration. For details on network addressing, see the
appendix "Internetworking Primer."
Before continuing the configuration process, check the current state of the access server by
entering the show version command. The show version command will display the release
of Cisco IOS software that is available on the access server.
Configuring the Access Server Using the Configuration Mode
You can configure the access server manually if you prefer not to use the setup facility or
AutoInstall. Take the following steps to configure the access server manually:
Step 1
Step 2
Step 3
Step 4
4-6 Cisco 2500 Series Access Server User Guide
You will need to acquire the correct network addresses from your system
Connect a console terminal by following the instructions described in the section
"Connecting the Console Terminal and Modem" in the chapter "Installing the
Cisco 2500 Series Access Server" and then power up the access server.
When you are asked if you would like to enter the initial dialog, answer no to go
into the normal operating mode of the access server:
Would you like to enter the initial dialog? [yes]: no
After a few seconds you will see the user EXEC prompt (Router>). Type enable
to enter enable mode. Configuration changes can only be made in enable mode:
Router> enable
The prompt will change to the privileged EXEC prompt:
router#
Enter the command config terminal at the enable prompt to enter configuration
mode from the terminal:
router# config terminal