- ページ 3

サーバー Cisco 700 seriesのPDF スタートマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 700 series 27 ページ。 Using profiles
Cisco 700 series にも：クイック・スタート・マニュアル (8 ページ), 概要 (19 ページ), ユーザーマニュアル (9 ページ), 管理マニュアル (36 ページ)

Warning

IMPORTANT SAFETY INSTRUCTIONS

This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any

equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for

preventing accidents. Use the statement number provided at the end of each warning to locate its translation in

the translated safety warnings that accompanied this device. Statement 1071

SAVE THESE INSTRUCTIONS

Warning

Read the installation instructions before you connect the system to its power source. Statement 1004

Warning

Installation of the equipment must comply with local and national electrical codes. Statement 1074

Warning

This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the

protective device is rated not greater than:

20A. Statement 1005

Warning

Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless

the device has been modified to be especially qualified for such use. Statement 245B

Warning

In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9

inches (20 cm) or more from the body of all persons.

Statement 332

Caution

The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout

force of 20 lbs (9 kg) and must use all 4 holes on the mounting bracket.

This product and all interconnected equipment must be installed indoors within the same building, including the

Caution

associated LAN connections as defined by Environment A of the IEEE 802.af Standard.

Note

The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National

Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should

not install the power supply or power injector in air handling spaces.

Use only with listed ITE equipment.

Note