Cisco 700 series 시작하기 매뉴얼 - 페이지 3
{카테고리_이름} Cisco 700 series에 대한 시작하기 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco 700 series 27 페이지. Using profiles
Cisco 700 series에 대해서도 마찬가지입니다: 빠른 시작 매뉴얼 (8 페이지), 개요 (19 페이지), 사용자 설명서 (9 페이지), 관리 매뉴얼 (36 페이지)
페이지 인쇄
Warning
IMPORTANT SAFETY INSTRUCTIONS
This warning symbol means danger. You are in a situation that could cause bodily injury. Before you work on any
equipment, be aware of the hazards involved with electrical circuitry and be familiar with standard practices for
preventing accidents. Use the statement number provided at the end of each warning to locate its translation in
the translated safety warnings that accompanied this device. Statement 1071
SAVE THESE INSTRUCTIONS
Warning
Read the installation instructions before you connect the system to its power source. Statement 1004
Warning
Installation of the equipment must comply with local and national electrical codes. Statement 1074
Warning
This product relies on the building's installation for short-circuit (overcurrent) protection. Ensure that the
protective device is rated not greater than:
20A. Statement 1005
Warning
Do not operate your wireless network device near unshielded blasting caps or in an explosive environment unless
the device has been modified to be especially qualified for such use. Statement 245B
Warning
In order to comply with FCC radio frequency (RF) exposure limits, antennas should be located at a minimum of 7.9
inches (20 cm) or more from the body of all persons.
Statement 332
Caution
The fasteners you use to mount an access point on a ceiling must be capable of maintaining a minimum pullout
force of 20 lbs (9 kg) and must use all 4 holes on the mounting bracket.
This product and all interconnected equipment must be installed indoors within the same building, including the
Caution
associated LAN connections as defined by Environment A of the IEEE 802.af Standard.
Note
The access point is suitable for use in environmental air space in accordance with section 300.22.C of the National
Electrical Code and sections 2-128, 12-010(3), and 12-100 of the Canadian Electrical Code, Part 1, C22.1. You should
not install the power supply or power injector in air handling spaces.
Use only with listed ITE equipment.
Note
3