サーバー Cisco Firepower 1120のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 1120 10 ページ。 Connected grid router
Cisco Firepower 1120 にも: ハードウェア・インストール・マニュアル (30 ページ), インストレーション・マニュアル (6 ページ), マニュアル (6 ページ), ハードウェア・インストール・マニュアル (42 ページ), 配備マニュアル (8 ページ), はじめに (42 ページ), ハードウェア・インストール・マニュアル (42 ページ)
Connecting the Router to Power
This section describes how to connect the Cisco 1120 Connected Grid Router to AC and DC power source
These topics are discussed:
Before You Begin, page 43
AC Power Connection Information, page 45
Connect to AC Power, page 49
Connect to DC Power, page 50
Power Cycling the Router, page 51
Before You Begin
Before you connect power to the router, read these topics:
Verify Router Hardware Readiness, page 43
Tools and Materials You Supply, page 43
Safety Information, page 44
Verify Router Hardware Readiness
Before connecting the router to power, verify the following:
The unit is grounded as described in
The SD flash memory module is installed correctly as described in
Tools and Materials You Supply
You must provide the following tools and materials to connect the router to AC power or optional DC power:
Note:
For the AC power connector, a 5-way screw terminal printed circuit board plug connector manufactured by
Phoenix Contact (part number 1913604) is supplied.
Note:
For the DC power connector, a 2-way screw terminal printed circuit board plug connector manufactured by
Phoenix Contact (part number 1912184) is supplied.
Wire-stripping tool
Flat-blade screwdriver
Mounting the Router, page
Cisco Systems, Inc.
www.cisco.com
43
33.
Using the SD Flash Memory Module, page
77.