- ページ 9

サーバー Cisco Firepower 1120のPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco Firepower 1120 42 ページ。 Connected grid router
Cisco Firepower 1120 にも：ハードウェア・インストール・マニュアル (30 ページ), インストレーション・マニュアル (6 ページ), クイック・スタート・マニュアル (10 ページ), マニュアル (6 ページ), ハードウェア・インストール・マニュアル (42 ページ), 配備マニュアル (8 ページ), はじめに (42 ページ)

Overview

Note

External Flash Storage

Package Contents

The following figure shows the package contents for the Firepower 1100. Note that the contents are subject

to change, and your exact contents might contain additional or fewer items.

Note

For Windows operating systems, you must install a Cisco Windows USB Console Driver on any

PC connected to the console port before using the USB console port. See

Port with Microsoft Windows, on page 29

The chassis contains a standard USB Type A port that you can use to attach an external device. The USB

port can provide output power of 5 volts, up to a maximum of 1 A (5 USB power units).

• External USB drive (optional)—You can use the external USB Type A port to attach a data-storage

device. The external USB drive identifier is disk1. When the chassis is powered on, a connected

USB drive is mounted as disk1 and is available for you to use. Additionally, the file-system

commands that are available to disk0 are also available to disk1, including copy, format, delete,

mkdir, pwd, cd, and so on.

• FAT-32 File System—The Firepower 1100 only supports FAT-32-formatted file systems for the

external USB drive. If you insert an external USB drive that is not in FAT-32 format, the system

mounting process fails, and you receive an error message. You can enter the command format

disk1: to format the partition to FAT-32 and mount the partition to disk1 again; however, data might

be lost.

There are three sets of four screws that you can use to secure the chassis to your rack. Chose the screws

that fit your rack.

for information on installing the driver.

Cisco Firepower 1100 Series Hardware Installation Guide

Connect to the Console