- ページ 17
サーバー Cisco SCE8000 GBEのPDF 取り外しと交換の手順をオンラインで閲覧またはダウンロードできます。Cisco SCE8000 GBE 36 ページ。 10gbe platform
Cisco SCE8000 GBE にも: クイック・スタート・マニュアル (25 ページ), 設定マニュアル (18 ページ), インストール (21 ページ)
Chapter 9 Removal and Replacement Procedures
If the captive installation screws are loose, the EMI gaskets on the installed modules will push adjacent
Note
modules toward the open slot, reducing the opening size and making it difficult to install the replacement
module.
Remove the module filler plate by removing the two Phillips pan-head screws from the filler plate. To
Step 5
remove a module, follow the procedure in the
Fully open both ejector levers on the new module. (See
Step 6
Figure 9-10
SCE8000-SCM-E
OPTICAL
BYPASS1
OL-26784-02
Ejector Levers and Captive Installation Screws
OPTICAL BYPASS
CONSOLE
PORT1
10/100/
LINK/
1000
ACTIVE
"Removing a Module" section on page
Figure
STATUS
OPTICAL
AUX
PORT2
BYPASS2
10/100/
LINK/
1000
ACTIVE
Ejector lever
Cisco SCE8000 10GBE Installation and Configuration Guide
Installing a Module
9-20.
9-10.)
SCE8000 EXTENDED SERVICE CONTROL MODULE
MASTER
SYSTEM POWER
M AS TE R
SY ST EM PO W
ER
Captive
installation
screws
9-17