- ページ 7

サーバー Cisco SNS-3495 seriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco SNS-3495 series 19 ページ。 Sns-3400 series
Cisco SNS-3495 series にも：インストレーション・マニュアル (36 ページ), トラブルシューティングマニュアル (8 ページ)

Chapter 8

Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances

Note

Optional: Use this utility to make VLAN settings.

Step 7

Use this utility to set a default CIMC user password.

Step 8

Note

Press F10 to save your settings and reboot the server.

Step 9

Note

By default, the baud rate of the serial port is set to 115200. After you configure CIMC, log in to the

Note

CIMC user interface and change the serial port buad rate to 9600.

Before you enable DHCP, your DHCP server must be preconfigured with the range of MAC

addresses for this server. The MAC address is printed on a label on the rear of the server. This

server has a range of six MAC addresses assigned to the CIMC. The MAC address printed on

the label is the beginning of the range of six contiguous MAC addresses.

Changes to the settings take effect after approximately 45 seconds. Refresh with F5 and wait

until the new settings appear before you reboot the server in the next step.

If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on

the console screen during bootup.

Installation and Upgrade Guide for Cisco Secure Access Control System 5.6

Configuring CIMC

8-7