Cisco SNS-3495 series 설치 매뉴얼 - 페이지 7
{카테고리_이름} Cisco SNS-3495 series에 대한 설치 매뉴얼을 온라인으로 검색하거나 PDF를 다운로드하세요. Cisco SNS-3495 series 19 페이지. Sns-3400 series
Cisco SNS-3495 series에 대해서도 마찬가지입니다: 설치 매뉴얼 (36 페이지), 문제 해결 매뉴얼 (8 페이지)
페이지 인쇄
Chapter 8
Installing the Cisco SNS 3415 and Cisco SNS 3495 Hardware Appliances
Note
Optional: Use this utility to make VLAN settings.
Step 7
Use this utility to set a default CIMC user password.
Step 8
Note
Press F10 to save your settings and reboot the server.
Step 9
Note
By default, the baud rate of the serial port is set to 115200. After you configure CIMC, log in to the
Note
CIMC user interface and change the serial port buad rate to 9600.
Before you enable DHCP, your DHCP server must be preconfigured with the range of MAC
addresses for this server. The MAC address is printed on a label on the rear of the server. This
server has a range of six MAC addresses assigned to the CIMC. The MAC address printed on
the label is the beginning of the range of six contiguous MAC addresses.
Changes to the settings take effect after approximately 45 seconds. Refresh with F5 and wait
until the new settings appear before you reboot the server in the next step.
If you chose to enable DHCP, the dynamically assigned IP and MAC addresses are displayed on
the console screen during bootup.
Installation and Upgrade Guide for Cisco Secure Access Control System 5.6
Configuring CIMC
8-7