- ページ 18

サーバー Cisco UCS B200 M3のPDF インストールとサービスノートをオンラインで閲覧またはダウンロードできます。Cisco UCS B200 M3 28 ページ。 Blade server
Cisco UCS B200 M3 にも：インストレーション・マニュアル (34 ページ), インストールとサービスノート (36 ページ), インストールとサービスノート (37 ページ), マニュアル (8 ページ), アップグレードマニュアル (21 ページ)

CPU spares come with two syringes of thermal grease; one with a blue cap and one with a red cap. The

Note

syringe with the blue cap is used with this server.

Figure 15: Thermal Grease Application Pattern

Step 10

Replace the heat sink. See callout 4.

On certain models, heat sinks are keyed to fit into the plastic baffle extending from the motherboard. Do not

Caution

force a heat sink if it is not fitting well, rotate it and re-orient the heat sink.

Step 11

Secure the heat sink to the motherboard by tightening the four captive screws a quarter turn at a time in an X pattern

as shown in the upper right.

Memory and Performance

Installing Memory

To install a DIMM into the blade server, follow these steps:

Procedure

Step 1

Press the DIMM into its slot evenly on both ends until it clicks into place.

DIMMs are keyed. If a gentle force is not sufficient, make sure the notch on the DIMM is correctly aligned.

Be sure that the notch in the DIMM aligns with the slot. If the notch is misaligned you may damage the DIMM,

Note

the slot, or both.

Step 2

Press the DIMM connector latches inward slightly to seat them fully.