- ページ 37

サーバー Cisco UCS B260 M4のPDF インストールとサービスノートをオンラインで閲覧またはダウンロードできます。Cisco UCS B260 M4 46 ページ。 Blade server
Cisco UCS B260 M4 にも：インストールとサービスノート (50 ページ)

Servicing the Blade Server

The VIC 1340 is a specialized adapter that provides 2 x 40-Gb Ethernet or Fibre Channel over Ethernet (FCoE)

connectivity to the blade server. It plugs into the dedicated VIC connector and is the only adapter that can

plugged into the slot 1 connector.

You must remove the adapter card to service it.

Note

To install a Cisco VIC 1340 in the blade server, follow these steps:

Procedure

Step 1

Position the VIC board connector above the motherboard connector and align the captive screw to the standoff

post on the motherboard.

Step 2

Firmly press the VIC board connector into the motherboard connector.

Step 3

Tighten the captive screw.

Tip

Figure 22: Installing a VIC Adapter

Installing an Adapter Card

All the supported mezzanine cards have a common installation process. These cards are updated frequently.

Currently supported cards and the available models for this server are listed in the specification sheets at this

To remove a VIC, reverse the above procedure. You might find it helpful when removing the connector

from the motherboard to gently rock the board along the length of the connector until it loosens.

Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs