Cisco UCS B260 M4 Kurulum ve Servis Notu - Sayfa 37
Sunucu Cisco UCS B260 M4 için çevrimiçi göz atın veya pdf Kurulum ve Servis Notu indirin. Cisco UCS B260 M4 46 sayfaları. Blade server
Ayrıca Cisco UCS B260 M4 için: Kurulum ve Servis Notu (50 sayfalar)
Sayfayı Yazdır
Servicing the Blade Server
The VIC 1340 is a specialized adapter that provides 2 x 40-Gb Ethernet or Fibre Channel over Ethernet (FCoE)
connectivity to the blade server. It plugs into the dedicated VIC connector and is the only adapter that can
plugged into the slot 1 connector.
You must remove the adapter card to service it.
Note
To install a Cisco VIC 1340 in the blade server, follow these steps:
Procedure
Step 1
Position the VIC board connector above the motherboard connector and align the captive screw to the standoff
post on the motherboard.
Step 2
Firmly press the VIC board connector into the motherboard connector.
Step 3
Tighten the captive screw.
Tip
Figure 22: Installing a VIC Adapter
Installing an Adapter Card
All the supported mezzanine cards have a common installation process. These cards are updated frequently.
Currently supported cards and the available models for this server are listed in the specification sheets at this
To remove a VIC, reverse the above procedure. You might find it helpful when removing the connector
from the motherboard to gently rock the board along the length of the connector until it loosens.
Cisco UCS B260 M4 and B460 M4 Blade Server Installation and Service Note for Servers with E7 v4 CPUs
Installing an Adapter Card
29