- ページ 9

ゲートウェイ Cisco 1700 seriesのPDF マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1700 series 15 ページ。 Secure firewall management center
Cisco 1700 series にも：規制遵守と安全情報マニュアル (45 ページ), 設定マニュアル (25 ページ), アプリケーションノート (41 ページ), ハードウェアのトラブルシューティング (12 ページ), 概要マニュアル (13 ページ), 設定 (34 ページ), マニュアル (5 ページ), クイック・スタート・マニュアル (6 ページ), ハードウェア・インストール・マニュアル (46 ページ)

Appendix B

ROM Monitor

This will change the virtual configuration register to the value specified. The

value is always interpreted as hexadecimal. Entering confreg without an

argument displays the contents of the virtual configuration register and a prompt

to alter the contents by describing the meaning of each bit.

Whether or not an argument is provided, the new virtual configuration register

value is written into NVRAM, but it does not take effect until you reset or

power-cycle the router.

The following display shows an example of menu mode:

rommon 7> confreg

enabled are:

console baud: 9600

boot: the ROM Monitor

do you wish to change the configuration? y/n

enable

change console baud rate? y/n

enter rate: 0 = 9600, 1 = 4800, 2 = 1200, 3 = 2400

4 = 19200, 5 = 38400, 6 = 57600, 7 = 115200

change the boot characteristics? y/n

enter to boot:

0 = ROM Monitor

1 = the boot helper image

2-15 = boot system

Configuration Summary

enabled are:

diagnostic mode

console baud: 9600

boot: the ROM Monitor

do you wish to change the configuration? y/n

You must reset or power cycle for new config to take effect

78-5407-03

Configuration Summary

"diagnostic mode"? y/n

"use net in IP bcast address"? y/n

"load rom after netboot fails"? y/n

"use all zero broadcast"? y/n

"break/abort has effect"? y/n

"ignore system config info"? y/n

[0]:

Cisco 1700 Series Router Software Configuration Guide

[n]:

[0]:

[n]:

Configuration Register

B-9