ゲートウェイ Cisco 1700 seriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1700 series 25 ページ。 Secure firewall management center
Cisco 1700 series にも：規制遵守と安全情報マニュアル (45 ページ), マニュアル (15 ページ), アプリケーションノート (41 ページ), ハードウェアのトラブルシューティング (12 ページ), 概要マニュアル (13 ページ), 設定 (34 ページ), マニュアル (5 ページ), クイック・スタート・マニュアル (6 ページ), ハードウェア・インストール・マニュアル (46 ページ)

Configuring a Single-Port Ethernet WIC on a

Cisco 1700 Series Router

The Cisco WIC-1ENET is a single-port Ethernet interface card supporting 10BASE-T Ethernet. The

card provides the Cisco 1700 series router with additional Ethernet interfaces.

Figure 1

shows the Cisco WIC-1ENET interface card.

Figure 1

Cisco WIC-1ENET Interface Card

S E E M A N

U A L

B E F O R E

IN S T A L L

A T IO N

The LNK (physical layer link) LED is on when the IOS recognizes the Cisco WIC-1ENET card and the

connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off when

operating in half-duplex mode. Additionally, the Activity LED on the front of the Cisco 1700 series

router indicates that data is transmitted or received on the slot.

Note

The Cisco 1700 Router Hardware Installation Guide provides procedures for physical installation.

Although those instructions are for a WAN interface card (WIC), the procedures also apply to installing

this card.

This document contains the following sections:

Cisco WIC-1ENET Requirements

•

IOS Commands

•

Caveats

•