Cisco 1700 series Configuration Manual

Browse online or download pdf Configuration Manual for Gateway Cisco 1700 series. Cisco 1700 series 25 pages. Secure firewall management center
Also for Cisco 1700 series: Regulatory Compliance And Safety Information Manual (45 pages), Manual (15 pages), Application Note (41 pages), Hardware Troubleshooting (12 pages), Overview Manual (13 pages), Configuring (34 pages), Manual (5 pages), Quick Start Manual (6 pages), Hardware Installation Manual (46 pages)

Cisco 1700 series Configuration Manual
Configuring a Single-Port Ethernet WIC on a
Cisco 1700 Series Router
The Cisco WIC-1ENET is a single-port Ethernet interface card supporting 10BASE-T Ethernet. The
card provides the Cisco 1700 series router with additional Ethernet interfaces.
Figure 1
shows the Cisco WIC-1ENET interface card.
Figure 1
Cisco WIC-1ENET Interface Card
S E E M A N
U A L
B E F O R E
IN S T A L L
A T IO N
The LNK (physical layer link) LED is on when the IOS recognizes the Cisco WIC-1ENET card and the
connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off when
operating in half-duplex mode. Additionally, the Activity LED on the front of the Cisco 1700 series
router indicates that data is transmitted or received on the slot.
Note
The Cisco 1700 Router Hardware Installation Guide provides procedures for physical installation.
Although those instructions are for a WAN interface card (WIC), the procedures also apply to installing
this card.
This document contains the following sections:
Cisco WIC-1ENET Requirements
IOS Commands
Caveats
Related Documents
Safety Warnings
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
© 2005 Cisco Systems, Inc. All rights reserved.
L N K
F D X
W IC
1 E N E T
1 0 B T E T
H E R N E T