Cisco 1700 series Manual de configuração

Procurar online ou descarregar pdf Manual de configuração para Porta de entrada Cisco 1700 series. Cisco 1700 series 25 páginas. Secure firewall management center
Também para Cisco 1700 series: Manual de informações sobre conformidade regulamentar e segurança (45 páginas), Manual (15 páginas), Nota de aplicação (41 páginas), Resolução de problemas de hardware (12 páginas), Manual de síntese (13 páginas), Configuração (34 páginas), Manual (5 páginas), Manual de início rápido (6 páginas), Manual de instalação do hardware (46 páginas)

Configuring a Single-Port Ethernet WIC on a

Cisco 1700 Series Router

The Cisco WIC-1ENET is a single-port Ethernet interface card supporting 10BASE-T Ethernet. The

card provides the Cisco 1700 series router with additional Ethernet interfaces.

Figure 1

shows the Cisco WIC-1ENET interface card.

Figure 1

Cisco WIC-1ENET Interface Card

S E E M A N

U A L

B E F O R E

IN S T A L L

A T IO N

The LNK (physical layer link) LED is on when the IOS recognizes the Cisco WIC-1ENET card and the

connection is up. The FDX LED is on when the port is operating in full-duplex mode, and off when

operating in half-duplex mode. Additionally, the Activity LED on the front of the Cisco 1700 series

router indicates that data is transmitted or received on the slot.

Note

The Cisco 1700 Router Hardware Installation Guide provides procedures for physical installation.

Although those instructions are for a WAN interface card (WIC), the procedures also apply to installing

this card.

This document contains the following sections:

Cisco WIC-1ENET Requirements

•

IOS Commands

•

Caveats

•