Connecting a Cisco WIC-1ENET Card to the LAN
Respond to the prompt as follows:
b.
Would you like to enter basic management setup? [yes/no]: no
First, would you like to see the current interface summary? [yes]: no
Enter the host name of the router as follows:
c.
Configuring global parameters:
Enter the enable secret password as follows:
d.
The enable secret is a password used to protect access to
Enter the enable password as follows:
e.
Enter enable password: password
Enter the virtual terminal password as follows:
f.
The virtual terminal password is used to protect
Respond to the prompts as follows:
g.
Configure SNMP Network Management? [yes]: no
h.
Enter the IP address and subnet mask as follows:
Configuring interface parameters:
Do you want to configure Ethernet0
IP address for this interface: ipaddress
Do you want to configure FastEthernet0
The following configuration command script was created:
hostname Router
enable secret 5 $1$ANpR$LYOj7mFpk1TE7SSAXDgVA/
enable password password
line vty 0 4
password password
no snmp-server
!
!
ip routing
no bridge 1
!
Configuring the Interface
16
Enter host name [Router]: hostname
privileged EXEC and configuration modes. This password, after
entered, becomes encrypted in the configuration.
Enter enable secret: password
The enable password is used when you do not specify an
enable secret password, with some older software versions, and
some boot images.
access to the router over a network interface.
Enter virtual terminal password: password
Configure IP? [yes]: yes
Configure IGRP routing? [yes]: yes
Your IGRP autonomous system number [1]: 1
Configure bridging? [no]: no
Configure IP on this interface? [yes]: yes
Subnet mask for this interface [255.0.0.0] : netmask
Class X network is x.x.x.x, x subnet bits; mask is /x
interface? [yes]: yes
interface? [yes]: no
78-11422-03
ページを印刷する