Chapter 3
Installing the Router
Figure 3-23 Attaching Grounding Lug on Cisco 2691
Ground lug
attachment
Connect the other end of the ground lug wire to a grounding point at your site.
Step 5
Reconnect power and interface cables.
Step 6
Power on the Router
Take the following steps to power on the router:
Secure all power cabling when installing this unit to avoid disturbing field-wiring connections.
Caution
a. For routers with AC input, plug the router's power cord into a three-terminal, single-phase power
Step 1
source that provides power within the acceptable range.
b. For routers with DC input, follow the instructions in the
page
Power ON the router. The LED labeled SYSTEM on the front panel is on.
Step 2
Connecting to a Network
Connecting to a LAN
This section explains how to use the Ethernet and/or Token Ring ports to connect the router to the LAN.
•
•
Although the illustrations in this section show the Cisco 2611 router, the procedures are the same for
Note
all of the Cisco 2600 series routers.
OL-2171-02
AS YN C
31
30
27
26
29
AS YN C
25
24- 31
28
24
23
22
19
15
18
21
AS YN C
14
11
16- 23
20
17
13
10
AS YN C
16
9
8-1 5
12
8
7
6
3
2
5
AS YN C
0-7
4
1
0
3-13.
The basic Ethernet and Token Ring cables required to connect the router to a network are provided
with the router. (See
Table
For cable pinouts, refer to the online document Cisco Modular Access Router Cabling
Specifications on the Documentation CD-ROM that came with your router and on Cisco.com.
SEE MAN
UAL BEF
ORE INS
DSU
EN
TAL LAT ION
56K
ACT
100 Mbp
SEE MAN
s
UAL BEF
DSU
ORE INS
LINK
TAL LAT ION
ACT
56K
CF1
100 Mbp
s
FAST ETH
ERN ET
LINK
0/1
FAST ETH
ERN ET
0/0
CI SC O 26
91
3-1.)
Cisco 2600 Series Routers Hardware Installation Guide
Power on the Router
SEE MAN
UAL BEF
ORE INS
TAL LAT ION
CON SOL
E
AUX
"Wiring the DC Power Supply" section on
3-17
ページを印刷する